Xecuter CR3 PRO KIT (CORONA V3/V4) for XBOX360

The Xecuter CR3 Pro corona v3 v4 starter kit is here, with the release of the CR3 Pro for the older corona and trinity Xbox 360 Slim boards earlier this year came the very best possible booting times and tuning of those times thanks to the rater feature. Now the team has released their version of these chips for the Corona v3 & v4 boards as well, this posed a challenge to the team as those in the know knew that the post_out points had been removed from the corona v3 & v4 and this posed a challenge to the team to rebuild them so it was possible to make use of the rater feature which was one of the main selling points for the CR3 Pro range. We are very happy to say the team has achieved a working solution to this and is called fake post. If you are the owner of a corona v3 or v4 and want the very best then take a good look at the Xecuter CR3 Pro fake post Corona v3 v4 starter kit.

 

These starter kits come with the CR3 Pro corona v3 v4 chip itself, a QSB Post Slim v2 board, a wide range of Capacitors for tuning and of course the wires required for the install. Just like the other models of the CR3 Pro to make use of the rater feature you will require a J-R programmer v2, the old Nand-X does not support this latest tuning feature from the team so if you plan to use these chips and don’t already have a JRP v2 you should take a look at the ultimate kit to get started which includes a JRP v2 in the package along with everything else you need to get started with a Corona v3 or v4 board apart from the Corona 4GB R/W kit if you are planning on using these with a 4GB v4 board.

 

If you are planning on doing more than one console of course after you have bought the Ultimate kit you can just by the chips by themselves and do more consoles. But note you will need to also buy the PostFix adapter sold separately as it’s not included as part of the starter kit and the QSB v3 is also not included. Not everyone uses the QSB v3’s and for Corona v3 you can just solder wires to the nand read / write points and connect to the JRP v2. And for the Corona 4GB v4 the only use for the QSB v3 is if you want to use the USB Comm’s cable sold separately to read the CPU key over USB into J-Runner instead of using the Ethernet method. So in short if you already have the gear from the Ultimate kit and want to install on other consoles you will need one of these Xecuter CR3 Pro corona v3 v4 starter kits, then a PostFix adapter and you can decide if you want to use the QSB v3 or not.